A: Best is a relative term. Usage and budget will dictate which style of booth will work best in a given enviornment. A pre-sales consultation can help determine which booth is best for your requirements. 

Q: What are the permitting requirements for spray booths? 

A: Spray booth permitting requirements vary depending on the booths location. We offer permitting services and will deal directly with the city or county on behalf of our customers. 

Q: Can I buy a spray booth from China and install it myself or have another contractor perform the installation? 

A: Yes, we do sell spray booths outright, though we highly suggest using a licensed contractor who specializes in spray booth installations due to potential complexities with permitting, wiring and fire suppression regulations. 

Q: Another contractor installed my spray booth and now my roof leaks when it rains, can you repair it? 

A: Some installers take shortcuts when piercing a customers roof for stack installation such as insufficient framing, or poor sealing of the roof-jack and/or rain collars. We can generally repair these types of problems if they are the cause of your leaky roof. Please be aware however, it is possible the water entrance point can be elsewhere on the surface of your roof and the stack opening simply provided a drain. If this is the case, you will need to contact a dedicated roofing company. Please contact us to schedule an inspection to determine the cause. 

Q: My neighbors complain about smelling paint when I spray, is there anything that can be done? 

A: Yes, we can increase the height of your exhaust or install a velocity cone at the discharge of the duct, effectively heightening your discharge will dilute the vapors to an acceptable level. 

Q: I am spotting cars with overspray in the parking lot, help! 

A: Low efficiency or improperly installed exhaust filters are the one and only reason you are spotting cars, please visit our supplies link to select an efficiency rating that is right for you, high capacity does NOT mean high efficiency, and vise versa. Always look for the paint load rating and the efficiency rating of a filter. Cheap filters last forever because they don’t trap anything. Expensive filters get changed often because they load and keep overspray where it belongs. Always be certain that filters are installed where NO air bypass occurs, taking a little extra time to tuck in the corners and make sure you have a good seal, air always follows the path of least resistance and the overspray follows right along. 

Q: The doors or panels on my booth are damaged or rotting away, can you repair or replace them? 

A: The extent of damage or decay dictates what will be required for a repair in these situations. Generally, we can fabricate custom components to save existing panels or doors. If the decay is beyond repair, we can install brand new spray booth doors or panels to bring your booth back to life. Contact us for further information about spray booth repairs. 

Q: What is infrared? 

A: Radiation, infrared is part of the electromagnetic spectrum, the effect which conversion by short-wave infrared heat is better than any other type of radiation. 

Q: What’s the reason of shortwave infrared used for painting heat? 

A: 1. Since the rules for control painting radiation was set forward, water-based paints and high solid paints are more and more popular, but these new type of paint need long drying time than traditional paint. 

     2. shortwave infrared can pass through the wet surface, drying from the bottom to the top, so paint not easy to wave and burst. 

     3. short-wave infrared heater reduced baking time , meanwhile improve the quality of painting.